Argument out of range

General Discussion
1

Dear all,

I performed the elastic simulation on a three-dimensional cube in FF++, using parallel computing mode (load “PETSc”). When I used two processors, the FF++ code is normal. However, as I used four or more processors, FF++ reported the error, i.e., Argument out of range. Was it because my computer configuration is too low?

Please give me some advice. I would appreciate it.

Best regards,
Liu

2

You need to share the code that is giving you the error, otherwise it’s difficult to help you.

4

The following code should run to completion.
Parallel_1.edp (4.7 KB)

5

Dear Professor,

Thank you from the bottom of my heart.

Best wishes,
Liu